1. Provisions for single-phase power socket wiring
There are a variety of single-phase sockets, often divided into two holes and three holes.
The two holes are arranged side by side, and the three holes are formed in a shape of a character.
The letter next to the wiring hole, L is the fire N is zero.
There is also E in the three holes, indicating that the ground is in the middle.
In the direction of the socket, the wiring of each hole is specified.
The left connected zero line is connected to the right and the protective ground line is connected to the center.
2, the choice of leakage protector
Select the leakage protector and the power supply mode is first.
Single-phase power supply 220, second-line secondary or single-stage.
Three-phase three-wire three-eighth, three-level protector is selected.
Three-phase four-wire three-eighth, four-wire three-level or four-level.
“Level†means that the switch contact “line†indicates the incoming and outgoing lines.
3, the reason why the light bulb does not shine
The light bulb is not bright, it is annoying, and the common cause is broken.
The transparent bulb can be seen, otherwise it can be tested with an electric pen.
When both ends of the switch point are closed, the fire line is not turned off.
When one light is off, the filament is broken, and both ends are turned off and the zero line is turned off.
4. Core inspection and breakpoint determination method before buried conductor is buried
Before the buried conductor is buried, there is no broken core disc inspection.
Check that the meter is used, and the L end is connected to the wire.
The other end of the wire is placed in the water.
Slowly shake the megohmmeter, the needle is less than zero is broken.
Find where the breakpoint is, use the instrument DG3,
One-phase AC is connected to one end, and the instrument is buried in the ground.
Slowly moving from head to tail, the lamp light is not broken,
If the instrument light is off, here is the disconnection point.
5, low-voltage electroscope to determine the method of AC single-phase circuit failure The electric pen for AC electroscope is lit, and the fire line is not bright.
Circuit failures can be checked and energized to measure fire and ground.
When the device is turned on and off, the circuit is disconnected and unquestionable.
If both ends are not lit, the power line is disconnected.
If both ends are bright, the zero line breaks or detaches.
6. Method for measuring DC current with pointer multimeter Zero before measurement, the range selection should be moderate.
Determine the positive and negative circuits, the serial wiring should be clear.
The black test lead is connected to the negative pole and the red test lead is connected to the positive.
If the hands are reversed, the wiring is positive and negative.
7. Method for measuring conductor DC resistance by pointer type multimeter
Measure the resistance selection range, select the range and then zero.
Two shorts to see the hands, not to adjust at zero.
Rotate the ohms zero button and the hand is zero.
There are still a number of knobs, and the battery is replaced and adjusted.
The contact must be good, and the two hands should be suspended.
The measured values ​​are guaranteed to be accurate and the hands are preferably in the grid. Flat Cable
Antenk offers flat cables from its own production – the location of the in-house Flat cable production is the antenk factory in shenzhen,Made in China. The FLAT CABLES are produced with latest state of the art production facilities and fulfill the Automotive standards.
Flat cable is a standard organization and is suitable for mobile electrical equipment with AC rated voltage of 450v/70v and below. Flat structure is especially suitable for frequent bending occasions, without kinking and folding neatly, such as driving. Yb, YBF and YBZ products can meet the needs of various occasions. It is suitable for the electrical connection between mobile electrical equipment in the harsh environment of power generation, metallurgy, chemical industry, port and so on.
Flat Cable
ShenZhen Antenk Electronics Co,Ltd , https://www.antenksocket.com