Nut mobile phone disassembly exposure: Snapdragon 615 processor + Hynix memory
After more than a year, under the close attention of a large number of hammer powder and hammer black, the hammer finally released the nut phone. Although everyone expects the T2 not to come, the high cost performance and high force of the nut still attracts a lot of evaluation media. They have successively offered their own feelings, disassembled and analyzed, and let us know its internal situation. The nut phone is a new sub-brand of Hammer Technology following Smartisan, targeting young people.
Main configuration:
Qualcomm Snapdragon 615 eight-core 64-bit processor
Adreno 405 GPU, 2GB RAM
Built-in storage space 16GB/32GB
Adopt 5.5 inch 1080p screen
Using Corning's third-generation gorilla glass, NTSC color gamut up to 80%, front 5 megapixel camera, rear 13 megapixel camera, aperture is f / 2.2, battery capacity up to 2900mAh, support mobile Unicom dual card 4G (non Blind insertion).
Pre-installed Smartisan OS 1.5.2 (up to Smartisan OS 2.0), the body size is 153x77x9mm, weighs 155g.
As the saying goes, "Buy or buy, see dismantling." Let's take a look at the work and then decide...
Directly see the main points:
The back cover can be directly buckled from the bottom, a thin, relatively hard plastic material with no elasticity. The small chip on the back cover is used to identify the color of the back cover and automatically switch the corresponding theme.
The inner back is similar to the general thousand machine, but the dual SIM card slot is integrated inside.
NFC is also designed on the battery, so you can change the back cover and non-removable battery. The battery capacity is 2900mAh.
The outer lens of the camera is coated, which is lower than the horizontal level of the back cover and is not easy to wear.
Rare black circuit board, eight or nine cable.
The light and distance sensors are integrated into the handset, which is simple, but assembly, disassembly, and maintenance are cumbersome and require custom components.
On the back of the motherboard is the Snapdragon 615 processor and Hynix memory.
The chip with large heat is covered with a layer of thermal adhesive, which is combined with copper foil, graphite heat sink and magnesium alloy to dissipate heat. It has a graphite heat sink than charm blue and red rice.
There is a white gauze next to the back camera, which is purely decorative.
The headphone jack is not seated with the motherboard, but is glued separately, just to ensure that it is centered on the side.
Finally, teach you a three-second dismantling method: enter the desktop, meditation on the craftsman spirit, pull down the thumb, disassemble, and test the pro.
Summary: In terms of industrial design, Hammer Technology invited Li Jianye, former president of Philips Asia Design Center, as the chief designer of the nut phone; in the design language, the nut phone removed the design of the physical key, but the phone back is still marked The hammer technology logo, the nut brand logo was not shown at the entire conference.
Electronic enthusiasts "Wireless Communications Special Edition", more quality content, download now
SMD transformer Description: small size, high working frequency, high adhesion performance, small distribution inductance;It is mainly used for module power supply, laptop, mobile phone and ultra-thin electric appliance.
The transformer consists of an iron core (or magnetic core) and a coil. The coil has two or more windings, of which the winding connected to the power supply is called the primary winding and the rest is called the secondary winding.It can change ac voltage, current and impedance.The simplest core transformer consists of an iron core made of a soft magnetic material and two coils with different turns on the core.
SMD Transformer, Ee16 Transformer, Power Transformer, Electric Transformer
YANGZHOU POSITIONING TECH CO., LTD. , https://www.cnpositioning.com