Change and power distribution station suddenly power off processing - Database & Sql Blog Articles

Probe domestic switch needle KG-300K needle head diameter is 3.0mm normally open switch needle

MOS power IC full range

SMD aluminum electrolytic capacitor

KKST patch plug-in active passive crystal oscillator hot sale 24.576000MHZ

Once the transformer and power distribution station suddenly lose power, they should be processed as follows:
First open the relevant power switch, then check the internal equipment and incoming line of the transformer, power distribution station. If it is confirmed that the cause of the power failure is not caused by the company, the following measures can be taken:
(1) When the dual power supply is receiving power, according to the relevant regulations of the switching operation, the standby power supply is switched to receive power; if the single power supply is receiving power, you can contact the power supply bureau and wait for the incoming call.
(2) If there is any indication of failure of the equipment, the relevant circuit breaker and knife gate should be quickly opened, the faulty equipment should be disconnected, the cause of the power switch rejection should be checked, and the power supply bureau should be reported immediately. The backup power source must not be enabled when the faulty device is not disconnected or cannot be disconnected.
(3) If there is a small generator set, a small generator can be started, but it is absolutely forbidden to reverse the power to the system.